JMP Knowledge Base

Latest Posts

• JMP® Clinical 8.0 produces an error that states that no subjects are found for data in non-English languages

  JMP Clinical 8.0 has an issue that affects many reports that use non-English data. An error message about this issue can look similar to the following...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:39 PM

  177 views | 0 replies

• The SHASHInv function produces incorrect results in JMP® 14

  In JMP 14 the SHASHInv function is supposed to be defined by the following mathematical equation: SinH( (ArcSinH( x ) - gamma) / delta ) * sigma + th...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:39 PM

  107 views | 0 replies

• Translation files for "Overall Response" for oncology analysis

  In Chinese, there are four meanings of "Overall Response," with different translations in Chinese. These terms, loosely translated into English, are "...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:39 PM

  142 views | 0 replies

• JMP® Clinical 7.1.2 Risk Based Monitoring might result in errors when you add supplemental data

  This note addresses several issues with JMP Clinical 7.1.2 Risk Based Monitoring when supplemental data is used. While adding supplemental data, JMP C...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  117 views | 0 replies

• The Adverse Events Time to Event in JMP® Clinical 7.1 might incorrectly calculate days when datetime variables are used

  In JMP Clinical 7.1, the Adverse Events Time to Event might incorrectly calculate days when using datetime variables. The error arises because JMP Cli...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  88 views | 0 replies

• JMP® Clinical 7.1.2: the Profile y-axis label panel does not adjust according to legend size when the Chinese language is used

  In JMP Clinical 7.1.2, there is insufficient width for the y-axis label for Patient Profile and Medical History. The legend box appears to be very nar...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  79 views | 0 replies

• JMP® Clinical might crash when you attempt to close the Review Builder via an API call

  When you attempt to close the Review Builder via an API call, JMP Clinical might crash. This issue is corrected in the JMP^® Clinical 7.1.2 hot fix (li...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  237 views | 0 replies

• Incidence Screen label names are truncated on graphs and in data tables

  In JMP^® Clinical 7.1 in Incidence Screen output, when there are long values within a column that are used as label names on graphs or in data tables, ...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  153 views | 0 replies

• Lower-level terms are not represented in the Term Type distribution in the Standardized MedDRA Queries Distribution report

  In the Standardized MedDRA Queries Distribution report in JMP^® Clinical 7.1, if you click the Show Events Leading to SMQs action button, lower-level t...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  250 views | 0 replies

• The error message "No SMQs are available based on the dialog selections" appears on the Standardized MedDRA Queries Incidence Screen

  In JMP^® Clinical 7.1, the following errors might appear on the SMQ Incidence Screen: Error:  No SMQs are available based on the dialog selections
  Error...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  204 views | 0 replies

• Metadata table files are overwritten if a mapped drive connection is lost when managing a configuration

  In JMP^® Clinical 7.1, if a mapped drive connection is lost while managing a configuration, metadata files are overwritten. You might encounter the fol...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  230 views | 0 replies

• The error "Variable xxTESTCD is not on file WORK.xx" might occur when findings are ADaM data sets and the variable xxTESTCD is not present

  In JMP^® Clinical 7.1, the AE Narrative might result in the following error when the ADaM data sets are used:  ERROR: Variable xxTESTCD is not on file ...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  259 views | 0 replies

• JMP® Clinical 7.1 displays a zero size on disk for studies containing .xpt files that are changed to .sas7bdat files

  For a study that contains transport (.xpt) files, JMP^® Clinical reports a nonzero size on disk. However, if the .xpt files are replaced with the corre...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  221 views | 0 replies

• The Overall Percent Occurrence is not recalculated in the AE Distribution report when you make a selection in the Review Subject Filter

  In the JMP^® Clinical Adverse Events Distribution report, the Overall Percent Occurrence is not recalculated when you use the Review Subject Filter to ...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  183 views | 0 replies

• The offset slider in the Adverse Events Time to Event report does not add time to the "Days of Exposure" calculation

  In the JMP^® Clinical 7.1 Adverse Events Time to Event report, if you add time to the offset slider to look for events, the slider does not also add ti...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  181 views | 0 replies

• You see a syntax error after you run an AE Narrative report in JMP® Clinical 7.1 on a Chinese operating system

  Running an AE Narrative report in JMP^® Clinical 7.1 on a Chinese operating system might produce the following error: ERROR 22-322: Syntax error, expec...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  207 views | 0 replies

• JMP® might crash if you open a table that uses the List Check property for columns and the table was also created in JMP® 15

  A table created in JMP 15 that uses the List Check property can crash JMP when the JMP version is earlier than JMP 15. In some cases, the table can be...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  75 views | 0 replies

• JMP® Clinical 7.1 subjects are dropped from the narrow search in the Standardized MedDRA Queries Incidence Screen report

  In JMP Clinical 7.1, the counts are not correct in the narrow search from the Standardized MedDRA Queries Incidence Screen report. When a subject has ...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  151 views | 0 replies

• Running Patient Profiles in JMP® Clinical 7.1 produces an error when the EX data set does not contain EXTRT

  When the EX data set is missing the EXTRT variable, running Patient Profiles in JMP® Clinical 7.1 produces the following error: ERROR: The following ...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  253 views | 0 replies

• Enhancements to JMP® Clinical 7.1

  The following is a list of enhancements to JMP Clinical 7.1, found in the JMP Clinical 7.1.1 hot fix. Adverse Event Narrative: Use CMCAT/MHCAT to dete...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  260 views | 0 replies

• JMP® Clinical 7.1 AE Narrative "ByNarrativeCategoryDetails" template not not populated diagnosis heading if MHCAT value for cancer history is missing

  The Adverse Event Narrative template "ByNarrativeCategoryDetails" has a section in the heading for "Diagnosis" that is populated when MHCAT=CANCER HIS...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  192 views | 0 replies

• JMP® Clinical 7.1 Adverse Event Narrative templates do not split prior and con meds based on study day

  In JMP Clinical 7.1 there is not a standard way of splitting medications into prior treatment vs. on treatment. This hot fix standardizes this based o...

  laura_archer

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  181 views | 0 replies

• The default configuration for JMP® Clinical 7.1 fails on a new installation if files referencing a previous partial installation still exist

  When opening JMP® Clinical 7.1 after a new installation, the default configuration fails if files referencing a previous partial installation still ex...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  182 views | 0 replies

• In JMP® Clinical 7.1, Add Study fails when a study is blinded and has SUPPDM but no ADSL data set

  When a study is blinded and has SUPPDM but no ADSL data set, refreshing the study metadata produces an error.  As a workaround, create an ADSL data se...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  200 views | 0 replies

• In JMP® Clinical 7.1 AE Narratives, Prior Therapy is Incorrectly Populated

  In JMP® Clinical 7.1 AE Narratives, a prior therapy may be populated for a subject that does not have one. The values come from cases where the previo...

  sseligman

  JMP Knowledge Base |

  Nov 30, 2022 1:38 PM

  168 views | 0 replies