Welcome to the JMP User Community!

Latest Discussions

• Comparing failure rates between two processes

  Process A has 2 fails out of 1000 units and Process B has 4 fails out of 750 units. Point estimates of failure rate are 2/1000 = 0.002 and 4/750 = 0.0...

  cfs_analyst

  Discussions |

  Mar 13, 2024 11:47 AM

  1458 views | 5 replies

• Formula plot in graph builder

  I performed a curve fit in JMP and saved the formula to a column (see below). I would like to be able to have the same curve appear in Graph Builder. ...

  scott1588

  Discussions |

  Mar 13, 2024 11:36 AM

  2257 views | 9 replies

• Column Switcher Appled to All Open reports

  Hi guys, I am trying to write a script to apply column switcher to all open reports. Please guide me dt = Current data Table(); //Get all Open reports...

  ComplexNerd

  Discussions |

  Mar 13, 2024 11:00 AM

  1010 views | 4 replies

• Curiosity question: How can a DoE factor setting cube with >3 dimensions be explained.

  Dear JMP-expert,I have a very general and maybe stupid question.After a DoE plan is sketched I usually use the 3D scatterplot to check the  factor set...

  DualARIMACougar

  Discussions |

  Mar 13, 2024 10:32 AM

  928 views | 2 replies

• Interpretation related to response model (RSM)

  I attached an image. Please advise me on the following:1) Actual by predicted plot: What is the red line, light red zone, and how should be the light ...

  sam8546

  Discussions |

  Mar 13, 2024 10:03 AM

  3147 views | 6 replies