Welcome to the JMP User Community!

Latest Discussions

• Structural Equation Model Standardized Path Coefficients Greater than 1

  Hi! I just built a structural equation model including two latent variables. Each latent variable has three indicators. However, after running the model, there are three standardized path coefficients greater than 1 (water quality > St[Mac... MMI]; latent 1 > St[Mac... MMI]; St[Base...Index] > St[Mac... MMI]). Normally the standardized path coefficients should be less than 1. I did some search and...

  lujc07

  Discussions |

  Oct 2, 2021 7:07 AM

  7825 views | 4 replies

• Spec limit, capability analysis

  I am attempting to define a measurement target using JMP, in other words a spec limit.  I recall in my past work using minitab decades ago, the capability function was helpful and it actually produced a USL. How would you approach in setting a target via JMP?  I've reviewed the distribution, control chart, and capability analysis in JMP 14. I realize I need to brush up on a few things and apprecia...

  Lex

  Discussions |

  Oct 1, 2021 1:26 PM

  1548 views | 1 replies

• Can you resize radio boxes?

  Hi All,   I've been looking to see if it's possible to resize radio boxes or the panel box that the radio box is in. So far, it seems that it's only possible to resize panel boxes if they contain list boxes, but not radio boxes. If you do it at the Panel Box() or Radio Box() level, the contents are empty in the panel box. If you define the Radio Box() as a variable, say "rb" and then call rb << Se...

  SDF1

  Discussions |

  Oct 1, 2021 12:23 PM

  1276 views | 2 replies

• Error Message "Please select the rows to be deleted"

  Hi,when I am running JSL script, there is message in the log,  "Please select the rows to be deleted".But the script is still running. I could identify anything error in my code.Does anyone know what will cause this error? dt1 << Select Where(:Tcount > 40); dt1 << Delete Rows;

  bzanos

  Discussions |

  Oct 1, 2021 7:13 AM

  1999 views | 5 replies

• Calculation of utilities without using JMP

  Good afternoon, I have made a discrete choice model, however I need to calculate the utilities of each combination outside the software. For this I use the estimates given by the software, but the estimates for the high attributes, reference attributes, do not appear in it. I have tried with the value of 0 for this estimate but the utility is not the same as those calculated by the software. Does ...

  SalimShalom

  Discussions |

  Oct 1, 2021 4:58 AM

  908 views | 1 replies