Welcome to the JMP User Community!

Latest Discussions

• DoE custom designs - include factors that are mutually exclusive

  Hi JMP community.   I just started my DoE journey on JMP recently. Sorry if I am missing anything obvious here.    I am trying to work out a DOE design of a biological process that have 4-5 factors. Factor A, B and C are mutually exclusive e.g. if factor A is present then B and C are not, vice versa.   I have found a previous discussion here in the community Defining Factor Constraints in Custom D...

  modelcitizen89

  Discussions |

  May 19, 2021 5:51 AM

  2183 views | 4 replies

• Ignoring "Excluded" rows

  Hello, I'm still trying to get over the JSL "hump," so forgive the fundamental question.The issue:- I have a sample table that contains data sets for three replicates with sample suffix a1, a2, and a3.- At times, one of the replicates needs to be set to the "Excluded" state (example below is a2)- I'm writing a batch script that will open a table and apply calculations only sets that were not exclu...

  NRW

  Discussions |

  May 19, 2021 5:31 AM

  2124 views | 5 replies

• JSL creating a spine line for changing group each time

   Hello,I have this script: dt = Current Data Table(); listX = {"1","2"}; listY = {"test1", "test2", "test3"}; fybx = dt << FitYByX( Y( Eval( listY ) ), X( Eval( listX ) ), Fit Where( :Group == "BL", Fit Spline( 0.1, Standardized, {Line Color( {213, 72, 87} )} ) ), try(Fit Where( :Group == "Value0", Fit Spline( 0.1, Standardized, {Line Color( {57, 177, 67} )} ) )), try(Fit Where( :Group...

  itzikd

  Discussions |

  May 19, 2021 2:29 AM

  1253 views | 2 replies

• Constrained variables query

  Hi,Can anyone advise a simple way to indicate that either a factor or an effect is constrained within limits ?  Examples would include numbers expressed as %'s which must therefore lie between 0 & 100, such as Purity or the Yield of a reaction.  This would be especially useful if it can be applied to a data table column, for example, rather than needing to be built into a custom design, thus enabl...

  NickT

  Discussions |

  May 18, 2021 11:54 PM

  1272 views | 4 replies

• Handling maintenance schedules in repairable systems simulation (RSS)

  Hi all, I didn't find a particular topic that addressed this so I was hoping to get some help from some of you folks that use RSS. Basically there's two things I'm trying to do in the simulation engine to account for real-life response for maintenance cycles:1) If I have two parallel components, both of which have failures and scheduled items, I would like to be able to suspend the scheduled item ...

  Norman

  Discussions |

  May 18, 2021 5:03 PM

  899 views | 1 replies