Welcome to the JMP User Community!

Latest Discussions

• Trend line

  Hello,I want to use JMP to create a trend line for stability parameters of drugs measured over time. For each batch produced, several formulations are taken and tested every three months. I want to check the trend of one of the parameters over time. For each time point, I have 6 measurements taken from different batches.I want JMP to calculate the average of the measurements for each time point an...

  Bar2024

  Discussions |

  Oct 6, 2024 10:33 AM

  6389 views | 8 replies

• How to access Here namespace during entered Local Here namespace?

  Hi all,I'm having trouble to access the Here namespace during entered Local Here namespace. My example script as follow: Names Default To Here(1); Delete Symbols(); // Declare a variable in the "Here" scope x = "Variable"; Local Here( // Access the "Here" scope variable y = Eval(Namespace("here") << Get("x")); Show(y); );When I used debugger, can clearly see after entered Local Here, i...

  nthai

  Discussions |

  Oct 6, 2024 12:11 AM

  1919 views | 7 replies

• How to Automate Analysis for Cyclic Data

  Dear JMP Community, I have an oven that cycle the temperature continuously (from Hot to Cold, then from Cold to Hot and repeat.....).The oven provide recording of the temperature vs time. If we plot Temperature @ Yaxis , Time @Xaxis, we get the attached graph. We need compute what is the rate of temperature change within specific range of temperature (in this case between 0dgC and 130dgC). For exa...

  Zappy

  Discussions |

  Oct 4, 2024 11:44 PM

  1446 views | 3 replies

• How to place outline boxes side by side in New Window(), and how to add scrolling to a report that was a fit group

  Hi all. I have the below new window script but am having trouble. I would like the plots and tests to be in there own columns (after the data and summary are stacked in the same column). Also, the plots and tests are reports that were once "fit group" output, and they are rather long so I would like to add a vertical scroll instead of having my window be the entire length of the output. Any ideas?...

  Abby_Collins14

  Discussions |

  Oct 4, 2024 7:26 PM

  934 views | 2 replies

• Forest plot add in bug?

  Hi everyone, I'm attempting to create a forest plot figure based on multiple logistic regression models. I have 9 independent variables and four IQ outcomes, VCI, POI, PSI and Full IQ. Each outcome has three thresholds <70 vs >=90, 70-79 vs >=90 and 80-89 vs >=90.All was fine but I detected some bugs when drawing the lines in the plot. For example, in females for Perceptual organization index (POI...

  emm84

  Discussions |

  Oct 4, 2024 10:41 AM

  2058 views | 2 replies