Welcome to the JMP User Community!

Latest Discussions

• JMP15 vs JMP16 speed

  We have number of scripts that are running scheduled nightly. One of the scripts is processing high number of files. Previously, it was processing around 6 files per minute on JMP 15. When we switched to JMP16, it started processing only ~3 files per minute. So overall run time increased from 6 hours to 12 hours. which in our case is unacceptable. We have already unchecked the hardware acceleratio...

  miguello

  Discussions |

  Aug 4, 2021 10:09 PM

  1219 views | 2 replies

• Issues with local data filter interactivity on HTML

  Hi, I am having issues in my html reports. I have tried plenty of ways to make it work, at first I tried making a dashboard through the dashboard builder including several graph builders within its content each with their own data filter and it didn't work when I tried to save it as an interactive html.
  I then followed the steps from the data filter tutorial in the following link, I tried to replic...

  Zuska-Ariri

  Discussions |

  Aug 4, 2021 7:15 AM

  1539 views | 1 replies

• jmp copy paste graph builder into word

  Dear all,ı need a help about JMP copy and paste into office documents. I routinely use JMP graph builder then paste them into word, PowerPoint. But, nowadays, I have an issue for it. When ı paste graphs into word or power points, you can see the below figure, half of the graph is not seen. This situation exists for each graph. Could you please help for this issue? BR

  nac

  Discussions |

  Aug 4, 2021 6:28 AM

  1917 views | 2 replies

• Broken Pipe Error

  Hi Everyone, Hope you're all well. I've been working on a GUI to run dimensionality reduction algorithms on gene-cell data in JMP, that uses the R-to-JMP interface. My script has worked on previous computers, but on my 2020 M1 MacBook Air, I get the error:"The request could not be completed due to an unexpected failure in write to proxy. The system error is 32 (Broken pipe)." What would be the pos...

  akfence

  Discussions |

  Aug 4, 2021 4:02 AM

  1250 views | 1 replies

• Threshold voltage Calculation

  I would like to add a new column 'Vth' in my table with the following calculation:-First I need to find the index i of column 'IDS' where the 'IDS' is nearest to 1e-9 (or Log10[IDS] = -9); and then Vth = VGS(i). It should be grouped by Site, Measurement, SWP, Device, Wafer columns as well. That is, each unique combination of Site, Measurement, SWP, Wafer, Device will have one Vth value.One techniq...

  pankajsync

  Discussions |

  Aug 3, 2021 8:58 PM

  4321 views | 6 replies