Welcome to the JMP User Community!

Latest Discussions

• Force stacking of control charts in Control Chart Builder?

  Is there any way to force stacking of control charts using "by variables" as shown in the example below? Weirdly, when applied to my original table (not anonymized), the control charts appear all in one, horizontal row with a long, long scroll bar. I want what is shown below. Possible?
  
   

  Ressel

  Discussions |

  Sep 30, 2024 8:44 AM

  701 views | 4 replies

• DoE when factors can not be changed independently

  Hi,Can DoE be used where factors can not be changed independently?  In the illustrative example attached, we want to maintain a response when changing the scale of manufacture from 21 L to 21 m3.  To do this we need to establish which mixing factor to maintain.  The effect of maintaining each mixing factor can in turn be assessed on an intermediate scale (as shown in the table), but the act of cha...

  kjwx109prime

  Discussions |

  Sep 30, 2024 7:38 AM

  1282 views | 2 replies

• Declaring a variable inside a column formula

  Hi,Is it good practice to declare a variable inside a column formula? Or does this create risk of errors? My formula works well, but I'm concerned that it might be unreliable. rownum = Row(); If( :Measurement type == "STUDY_VARIABLE", :Control means[Min( Current Data Table() << get rows where( :Measurement type == "STUDY_CONTROL" & :Control group == :Control group[rownum] ) )], :Control means...

  Asterix

  Discussions |

  Sep 30, 2024 7:32 AM

  659 views | 2 replies

• Can you use the Equivalence of means sample size calculator for attribute data?

  Hi,  Maybe i'm using the wrong type of test..but I would like to generate a sample size to compare two parts.  The test is an attribute test and I just want to verify the new part doesn't increase the failures by more than 10%.  This seemed like a non inferiority test when I first thought about it but playing around with the calculator, it seems like it's more of a test for variable data.  Am I ju...

  SerialDeviation

  Discussions |

  Sep 30, 2024 5:51 AM

  579 views | 1 replies

• Extracting Deltas between two tables serialized samples for multiple parametric measurements

  I have measured data for 50 serialized parts over three different temperature (Room, Hot, Cold) in three different tables.  Each serialized part has over 100 measured parameters.  I want to extract the deltas (Room - Hot) and (Room - Cold).  Putting these two calculations into two new tables would allow me to find the parts with the worst temperature deltas. i have tried Table compare, but it does...

  JBEng

  Discussions |

  Sep 30, 2024 4:47 AM

  507 views | 3 replies