Welcome to the JMP User Community!

Latest Discussions

• Quantiles with missing values

  If I have a column named X with 100 values which is a sequence from {1-100}, and I want to retrieve the 10 smallest values, I know I can use the command below:dt = current data table(); temp1 = dt:X << get values; temp2 = quantile(0.1,temp1); dt << get rows where(:X<temp2);Let's say I'm replacing the 10 largest values (i.e. 91-100) with missing values, is there a way to get the same 10 smallest va...

  Djtjhin

  Discussions |

  Jun 11, 2021 7:45 AM

  1855 views | 3 replies

• Process Capability Physical Boundaries

  How can one set physical boundaries in process capability analysis.  For example, when I evaluate capability to measure within specification of a trace element in a material, most data will be near zero, but cannot be less than zero.  This results in a highly skewed distribution with the bulk of the data piling up around zero and then the distribution has only a one-sided tail.  But the capability...

  Goblin_King

  Discussions |

  Jun 10, 2021 5:31 AM

  1416 views | 1 replies

• How to Highlight some distributions in graph

  Hello:) The figure above is a part of my question. As you can see at the picture, I want to highlight some elements whose Cpk is smaller than 1.Somebody help me.. Thank you in advance:) 

  yummy

  Discussions |

  Jun 8, 2021 3:52 PM

  1377 views | 1 replies

• Generalized linear model or Nominal Logistic for RNAseq data

  Colleagues,Imagine I have RNAseq data in the form of reads count measured in 2 environments, with 3 replicates each, in a single sequencing experiment. Like this:Env readsA         9A       10A       11B        4B        5B        6Of course I can treat each reads count as an independent variable and do a t test and I will have very low power. Instead, I want to be able to treat each read as an ob...

  l_yampolsky

  Discussions |

  Jun 8, 2021 12:30 PM

  4250 views | 8 replies

• Data Selection

  Hey,  I am using JMP Pro windows version. I can`t copy and paste data from the Distribution sheets in particular. I can find the selection tool or any other thing. It only gives me the sheet with none of the supported icons. I was using JMP on Mac previously and all were worked, but not now on the Pro Windows version. Any ideas?   

  BeesanW

  Discussions |

  Jun 8, 2021 6:10 AM

  1198 views | 1 replies