Welcome to the JMP User Community!

Latest Discussions

• Simulation de Monte-Carlo - Profileur

  Bonjour, A quoi correspondent les lignes rouges (en trait plein) dans les graphiques du profileur de défauts ? En fait, parfois il y a 2 lignes rouges  qui se coupent et quand on ajoute les ordonnées d'un point de l'une des deux lignes rouges avec l'ordonnée d'un point de même abscisse mais de l'autre ligne rouge  on obtient l'ordonnée d'un point de la ligne noire. Le learnbot n'a pas su me répond...

  rugolf

  Discussions |

  Jun 1, 2026 9:04 AM

  413 views | 0 replies

• JMP Live Local Data Filter Auto Update off by default?

  I've published a JMP Live report and realized the Auto-Update is true/on by default in Local Data Filter. Is there an option to turn that off by default?? This will be very helpful as I don't have to uncheck it every time I load the report. When multi-selecting the filters, I often realize after selecting first option since it tries to re-load the entire report and it takes time to reload with lar...

  DarthYoda

  Discussions |

  May 29, 2026 10:11 PM

  407 views | 0 replies

• Graph Builder line plot: Loss of detail at smaller frame sizes

  When graphing line plots at smaller frame sizes, data points seem to be omitted or summarised and detail lost. Attached are screenshots from the same measurement graphed four times, each time halving frame size, exported to PDF and then scaled up to the same height. As PDF is vector-based, the graphs should be scaled versions of each other, like the text of the axis title, but clearly they are not...

  PathReindeer523

  Discussions |

  May 26, 2026 5:48 AM

  562 views | 0 replies

• "Replace missing with previous value" for multiple column selection on JMP19

  Previous versions of JMP would let users select multiple columns and use the "Replace missing with previous value" option from the right-click drop-down menu, applying the function to all columns selected. With JMP19, I can only do it if I select one column at a time. Is there a way to keep doing with with multiple columns selected? 

  AcceptanceOwl96

  Discussions |

  May 13, 2026 9:59 AM

  358 views | 0 replies

• How to Look at Range Data High Medium Low

  Looking for the Best way to analysis Data when I have Ranges Upper, Mid and Lower for both Voltage and Freq. data.  See RED Columns.  Guess I could perform a Control Chart or Dist. but like to to see if their is a shift of this many Electrical Devices.   Any Suggestions?  

  CREV

  Discussions |

  May 8, 2026 2:34 PM

  402 views | 0 replies