Specify Contours for All Contour Plots (without a dialogue for each plot)
Jun 15, 2020 12:54 PM(246 views)
on JMP for Mac, v 14.3
I am plotting a two dependent variables using Graph-->Contour Plot with a "by" variable so I end up with 12 different plots. I want all the plots to have the same contours for correct comparison purposes.
Typically holding down the command key when I make a selection under the red carat applies changes to all the plots in the plot window.
With a Contour Plot and "Specify Contours", it behaves differently, requiring that I type in the 3 of 4 inputs for EACH plot.
I'm hoping there's some way to force them to all be the same with only 1 dialogue entry.
I looked for discussions addressing this and found none. Which makes me think there is an easy/obvious way to do this I don't know or it's not a common complaint/need of the community.