Welcome to the JMP User Community!

Latest Discussions

• Linux and Containerization Support

  Hello, I am looking to set up JMP and integrate with SAS 9.4. All our cloud infrastructure is based on Linux and Kubernetes. I am wondering if it is possible to install JMP on Linux or if there are containerized JMP images are available. 

  pizzaguy

  Discussions |

  Dec 18, 2023 4:52 PM

  3274 views | 6 replies

• Nonlinear platform - trial values from table with large number of categories

  Hello - I have a large number of categories for each parameter when using the nonlinear platform. Basically, one category per row. Is there a way to have a table of values to load into the parameters? Because with the time its taking to one by one type and click, type and click the values in with the control panel, it might be faster to go back to Matlab at this point, which I very much don't want...

  ehchandlerjr

  Discussions |

  Dec 18, 2023 2:50 PM

  649 views | 0 replies

• JMP Live data filter in control chart updates chart USL and LSL but not the points with a selection after data refresh

  I have a JMP Live control chart with a data filter. When i click the data filter it changes the control chart accordingly. However, when the data refreshes it no longer updates the points in the control chart. It will still update the shaded regions or other aspects of the chart with the data filter selection but not the points themselves. 

  bjbreitling

  Discussions |

  Dec 18, 2023 11:19 AM

  1322 views | 2 replies

• How to use prediction profiler to achieve a combination of target conditions?

  I have a 5 column data. Variation of input parameters/conditions in rows of the first three column results in (measured) values in column 4 and 5. How to use prediction profiler to predict a combination of input parameters/conditions to achieve a target combination (in my case a target concentration and depth)?I would prefer a graphical way but I can also handle JSL.  

  Neo

  Discussions |

  Dec 18, 2023 9:31 AM

  2341 views | 5 replies

• Definitive Screening Design question

  Should you only run a Definitive Screening Design if you know or think you're very close to the process optimum? What happens if you run a DSD, but you're outside the optimum factor space? Would you have wasted your time, and have been better off doing a fractional-factorial 1st to screen items, then doing the full factorial to get curvature afterward? 

  mjz5448

  Discussions |

  Dec 18, 2023 4:01 AM

  3323 views | 8 replies