Welcome to the JMP User Community!

Latest Discussions

• Permutation procedure for randomized block design

  I'm interested in conducting a permutation analysis. I have three treatments, with a randomized block design with seven blocks. I'd like to do a permutation procedure to test both the F value and for posthoc pairwise comparisons.

  Craig_Stockwell

  Discussions |

  Feb 9, 2021 12:27 PM

  2341 views | 4 replies

• Define Factor Constraints DOE Custom Design by Disallowed Combinations Script

  Hello together,Sorry in advance, I just startet using JMP. I have struggle adding a factor constraint script to my DOE. My constraint are as follows:Factor A^2 * Factor B <=200Unfortunately I'm not able to write the script like this, because I always get the JMP Alert: Invalid disallowed combinations script. See log for details. Where ist this log and do I have to add something?Best regards 

  Freddy

  Discussions |

  Feb 9, 2021 7:27 AM

  2814 views | 3 replies

• 2 constraints in custom DOE where the sum of two factors should be below 8 or greater than 18 hours

  Hi,I would like to run a custom DOE with 5 factors. 2 factors are related to time and due to work hours I have to ensure that the sum of those two factors either are below 8 hours OR greater than 18 hours. The first factor has 0.3 h as low level and 6 h as high whereas the second has 1 h and 20 h. The script below does not work, perhaps because there is an AND hidden...? thanks in advanceDOE( Cus...

  Sop

  Discussions |

  Feb 9, 2021 6:59 AM

  1791 views | 2 replies

• DOE Custom Design Conituous Factor Quadratic

  I have a DOE that I have setup to test for curvature in a continuous factor and the centerpoint that JMP selected is different than what I want to test.  For example: Low: 20Mid (JMP): 60; 50 is what I want to change it toHigh: 100 I can manually adjust the values in the Table of the designed study but I am concerned that the Design Evaluation would then not be accurate (i.e. Power Analysis, Fract...

  JMPAround

  Discussions |

  Feb 9, 2021 6:55 AM

  3668 views | 7 replies

• Mixture design question

  Hello everybody, I would like to know if it is possible to use a Mixture design if we want to study the impact of the proportion of the mixture factors but also the total quantity of the mixture.Basically I would have two mixture factors (corresponding to the proportion of my 2 components ) and a continuous factor to represent the total quantity of the mixture (e.g. from 100ml to 500ml). Is it pos...

  anne_sa

  Discussions |

  Feb 8, 2021 8:10 AM

  3214 views | 6 replies