Hello JMP Community, I work at a manufacturing facility as a Process Engineer. I am trying to find some standard or guidance on how to determine the operating window of identified Process Parameters following a Design of Experiment in JMP? Some background I performed a Design of Experiments and I analyzed the interactions and determined which Process Parameters (factors) were most significant with respect to my Product Characteristics (responses). I not only need to find the best running setting (target) to set my Process Parameters but also to find the operating window (lower and upper limit) to find the "cliff" where I will begin seeing defective product. Example: I have three inputs Pressure (continuous), Angle (continuous) , Heater (categorical). I have three outputs Pull Force (continuous), Pull Force Failure Mode (categorical), Length (continuous). I am attaching the DOE results for this example. So far I have used the Monte Carlo simulation yet haven't found a straightforward way to determine the operating window. Looking for some guidance and interested in an interactive explanation rather than scripting answer from this very knowledgeable community. Thanks, Jorge. EDIT 11/29/17: Added desirability to the spreadsheet. Desirability: Pull Force = 1, Pull Force Failure Mode = 2, and Length = 1
... View more