- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
Vibration Analysis: Fault Frequencies Correlations
Hello,
I am currently performing a vibration analysis using JMP for the first time. As data input I have FFT (Fast Fourier Transform) data from an extruder gearbox for 5 different time stamps (baseline, pre-event, post-event, 6 month increments after event X2). Each FFT data set comes with 16,000 frequencies (Hz) vs magnitudes (g). In vibration analysis the primary objective is to identify "fault frequencies" for bearings, gears, etc. These fault frequencies and respective harmonics have a specific frequency that when they become an issue, they will show up in an FFT with a significant peak.
My question for this community: is there to have JMP "look" for these known frequencies in this vast data pool of FFTs and extract their respective magnitud in order to observe their progression in time (and possibly their harmonics)? The only inneficient way I have managed to this is by using a script that compares the frequency in the FFT to these local constants (fault frequencies) and if they "match" within a tolerance, it prints the magnitud. However, it is not very efficient and considering I have 12 bearings and 9 gears, this process will take a very long time. I just know that JMP can do better than that!!
Thank you for any help or guidance you can provide!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
Re: Vibration Analysis: Fault Frequencies Correlations
Regards,
Phil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
Re: Vibration Analysis: Fault Frequencies Correlations
Do you have JMP Pro? You might try analyzing the spectra with the Functional Data Explorer. You could then save the functional principal components. You could fit a model with FPCs versus time or event versus FPCs.