User Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

  • JMP Security Notice: CVE-2026-109618 and CVE-2026-109619

    JMP promptly initiated a review of its products, services, and relevant infrastructure for exposure to CVE-2026-109618 and CVE-2026-109619.

    Our assessment of JMP products has not identified exposure to these vulnerabilities. Where remediation was required within supporting environments, appropriate security updates and controls have been applied and validated.

    We have identified no evidence of successful exploitation or unauthorized access to JMP systems or customer information associated with these vulnerabilities.

    JMP continues to monitor the issue and relevant vendor guidance. No action is required by JMP customers at this time.

  • Don’t miss your chance to experience Discovery Summit Europe at our best available rate! Early bird registration through 31 Oct.
  • Graph Builder Toolbar streamlines interactive graphing. Creates shortcuts on Report and GraphBuilder Helpers toolbars. Download and install the extension.

Discussions

Solve problems, and share tips and tricks with other JMP users.
Choose Language Hide Translation Bar
Eric_M
Eric_M
Level II

JMP 17 jitter selection not working for a single data subset

Created: Mar 1, 2023 02:17 PM  |  Last Modified: Jun 8, 2023 9:32 AM (2304 views)

Hello all,

I'm having an issue where I want to display data points with "packed" jitter, but graph builder isn't displaying one subset of data in this way (see group "D" in the first image below).  The two other subsets (D2, D3) display packed jitter as desired.  All columns in my data table are numeric, continuous.  I'm not sure if this has to do with the number of points - subset "D" has 129k points, subset D2 has 13k, and subset D3 has 16k points.  Another acceptable way to display this data would be contours, but graph builder doesn't display subset "D" at all when selecting contours (2nd image below).  Hoping the community can offer some suggestions.  Thanks in advance!

 

Eric_M_1-1677697971177.png

Eric_M_2-1677698032847.png

 

 

2 REPLIES 2
hogi
hogi
Level XIII

Re: JMP 17 jitter selection not working for a single data subset

Mar 2, 2023 05:33 PM (2277 views)  |  Posted in reply to message from Eric_M 03-01-2023

yes, seems to be caused by the number of points. a bit lazy.

I experienced the same some while ago: Graph Builder - small and big subset

 

The issue with contours is surprising - back then switching to contours was the solution in my case.

0 Kudos
data_nerd
data_nerd
Level II

Re: JMP 17 jitter selection not working for a single data subset

Feb 23, 2024 01:37 PM (2085 views)  |  Posted in reply to message from Eric_M 03-01-2023

I'm running into the same issue.

0 Kudos

Recommended Articles