Turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- JMP User Community
- :
- Discussions
- :
- Discussions
- :
- How to compare dose-response curves in JMP?

Topic Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

Highlighted

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Oct 9, 2013 7:34 AM
(5819 views)

Can anyone give me a simple protocol for using JMP to compare dose-response curves in JMP? The data tables consist of a series of treatments (concentrations of a specific compound). Several cell lines are treated the same way with the compound using the same concentrations and three replicate endpoints are measured for each compound. Typically we derive an IC50 (concentration inhibiting the endpoint by 50%) for each cell line. The comparison between cell lines is then done with replicate experimentally derived IC50's. However, I would like to compare the dose-response curves from each cell line using all the data from each concentration (treatment). Is there a simple protocol I can follow in JMOP for doing this? If you can point me to a step-by-step method it would be helpful. You can also write to me at oliver.flint@bms.com.

1 ACCEPTED SOLUTION

Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

See **Help** > **Books** > **Predictive and Specialized Modeling**. There is a chapter devoted to the Fit Curve platform, which can fit typical dose-response curve models, perform inverse prediction (e.g., LD50), test parallelism, and so on.

Learn it once, use it forever!

2 REPLIES 2

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: How to compare dose-response curves in JMP?

I too would like a reply to this question.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

See **Help** > **Books** > **Predictive and Specialized Modeling**. There is a chapter devoted to the Fit Curve platform, which can fit typical dose-response curve models, perform inverse prediction (e.g., LD50), test parallelism, and so on.

Learn it once, use it forever!