Hi everyone, i'm new to this forum and hope to get along with you all:) I'm a student using JMP but am facing some difficulties in scripting pertaining to the fit model part. The following illustrates the fit model code which i can't seem to get it working: a=0; var_list={:param1,:param2}; rs_list={ :test1,:test2,:test3,:test4,:test5 }; obj=Fit Model( Y( var_list[1] ), Effects( response surface( :test1,:test2,:test3,:test4,:test5 ) ), Personality( Standard Least Squares ), Emphasis( Effect Screening ), Run() ); if(a==1, obj<<Profiler(1, Confidence Intervals( 1 ),Desirability Functions( 1 ), var_list[1] <<Response Limits( {Goal( Maximize ), Importance( 1 )} ), maximize desirability(1), ); obj << {Lack of Fit( 0 ), Sorted Estimates( 1 ), Plot Actual by Predicted( 1 ), Plot Regression( 0 ), Plot Residual by Predicted( 0 ), Plot Effect Leverage( 0 )}; ); if(a==0, obj<<Profiler(1, Confidence Intervals( 1 ),Desirability Functions( 1 ), var_list[1] <<Response Limits( {Goal( Minimize), Importance( 1 )} ), maximize desirability(1), ); obj << {Lack of Fit( 0 ), Sorted Estimates( 1 ), Plot Actual by Predicted( 1 ), Plot Regression( 0 ), Plot Residual by Predicted( 0 ), Plot Effect Leverage( 0 )}; ); i have 10 variables in a list and would like to use them all to go through a series of least square analysis via fitmodelling but i can't seem to get it to work. the code above was initially planned to be inserted into a for loop to loop 10 times (this might vary as the number of variables might be more or less) but the thing is i would like to use a loop to command jmp to perform the desired analysis from the list above...also, is it possible to place rs_list into the response surface function above? (i can't seem to get the list to work too)...any ideas or advice is greatly appreciated! thanx in advance and have a nice day ahead!:)
... View more