Turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- JMP User Community
- :
- Discussions
- :
- Save limits of control chart to table in JMP 12 - bug?

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

Highlighted

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Jan 4, 2017 8:04 AM
(12228 views)

When I create an IR control chart through **Analyze > Quality and Process > Control Chart > IR**, I want to save the limits to a table. So in the chart screen, I click on the top-most red triangle and **Save Limits > in New Table**. After I click on this, a new table *does not* appear but an asterisk appears next to the column on the left hand side of the data table. The limits are saved to the column, not in a new table. Is this a bug in version 12 or am I doing something wrong?

Any help would be much appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

6 REPLIES 6

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: Save limits of control chart to table in JMP 12 - bug?

I should add that I never have this problem when I use version 11.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: Save limits of control chart to table in JMP 12 - bug?

I was uanble to replicate this problem using JMP 12.0. Does the following code work for you? (Note that I did try this through the interface as well with no issues.)

```
dt=Open("$SAMPLE_DATA/Big Class.jmp");
obj=dt<<Control Chart(
Group Size( 1 ),
KSigma( 3 ),
Chart Col( :height, Individual Measurement, Moving Range )
);
dtLimits=obj<<in new table;
```

If the following code does not work for you, I suggest contacting technical support at support@jmp.com. It could be a preference that you have set that is causing this issue. If the code above works for you, then perhaps the issue is data/example specific.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: Save limits of control chart to table in JMP 12 - bug?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: Save limits of control chart to table in JMP 12 - bug?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content

Re: Save limits of control chart to table in JMP 12 - bug?

Yeah, that must be it. I'll get in touch with technical support. Thank you so much Tonya.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Email to a Friend
- Report Inappropriate Content