topic Re: Fit Y by X and CDF plot in Discussions

Fit Y by X and CDF plot

adam — Tue, 03 Apr 2018 10:34:20 GMT

Hi Guys,

I have the following problem. I would like to do Fit Y-X(for one way plot) based on the table below and the the output is something like the attached plot whereby the X-axis is as shown. I knew that I can use Graph Builder but my final intention is to get a CDF plot that will have Test 101A and 102A appear side by side. I'm not sure if this is possible using Fit Y-X. If there is any better way, please suggest.

Thank you.

TEST	SEQUENCE	RESULT
101A	1000	1
101A	1000	2
101A	1000	2
101A	2000	3
101A	2000	3
101A	2000	1
101A	3000	2
101A	3000	1
101A	3000	1
101A	1000	1
101A	1000	2
101A	1000	3
101A	2000	3
101A	2000	1
101A	2000	3
101A	3000	2
101A	3000	3
101A	3000	3
102A	1000	1
102A	1000	3
102A	1000	1
102A	2000	2
102A	2000	3
102A	2000	2
102A	3000	2
102A	3000	1
102A	3000	1
102A	1000	1
102A	1000	2
102A	1000	3
102A	2000	2
102A	2000	3
102A	2000	2
102A	3000	1
102A	3000	3
102A	3000	2

Re: Fit Y by X and CDF plot

Phil_Kay — Tue, 03 Apr 2018 12:27:03 GMT

Hi,

I'm not entirely clear what your challenge is. Is it absolutely necessary to have the CDF plots side by side? Do you need to compare the CDFs?

Regards,
Phil

Re: Fit Y by X and CDF plot

adam — Wed, 04 Apr 2018 01:47:36 GMT

Hi,

Yes, in this challenge is to have them appear side by side for comparison purpose. Would it be possible to do it in JMP? If you have any suggestion, please recommend.

Thank you.

Re: Fit Y by X and CDF plot

txnelson — Wed, 04 Apr 2018 02:23:46 GMT

1. While there isn't an option within Graph Builder to generate CDF plots, you can easily generate your Graph Builder plot and then generate your Fit Y by X CDF plot, and since they appear in separate windows, you can move them side by side.

2. If this isn't complete enough, you can select the check box in the lower right hand corner of each of the 2 windows, and then click on the down arrow next to the check box, and specify "Combine Windows"

3. Or you can copy the windows a journal window. To create a new journal window go to:

File==>New==>Journal

The once the window is open, go to your Graph Builder window and click on it and then press and hold the Control Key followed by the J key. Finally, then go to the CDF window, and repeat the CNTL/J key strokes.

Now you can select and drag and drop the graphs to whatever position in the journal you want. Use the Tools from the Toolbar to select objects and then just click and drag the selected objects to where you want them

4. Finally, a JMP Script could perform these options for you, or a script could be written to generate the graphs from scratch and create them in whatever form you desire.

Re: Fit Y by X and CDF plot

adam — Wed, 04 Apr 2018 02:32:54 GMT

Thanks Jim for your help!